Be sure to have  ALL jewelry inspected by your jeweler to make sure that all the stones are secure in the mounting before using the Jeweler in the Dishwasher.

1.) Place jewelry inside of unit and twist to close, do not snap to shut.

2.)  Place jewelry inside the soaker tank. The interior wall of the soaker tank is removeable, so if you have a large piece that needs to be cleaned, remove the wall and set piece inside tank.  If you are cleaning a couple of pieces, leave the wall in place to keep jewelry from hitting against each other.  Once jewelry has been placed inside, close the lid.

3.)  Place eggs and soaker tank inside of large outer basket.  The rings on top of the eggs should be facing up, and the mesh lid on the soaker tank should be facing up.  The eggs rest on the circular nests inside of the outer basket, they do not fit down into the hole.  The soaker tank goes in the open area between the eggs.   (See picture above.)

4.)  Place outer lid on top of the eggs and soaker tank, the rings on top of the eggs should be facing straight up. Make sure all edges of the outer basket are lined up, then squeeze the two halves together to lock.  It works best to squeeze the area on top of the basket that is directly above the locks where the company logo is.

5.)  Place basket on the top rack of the dishwasher.

Run the dishwasher as you normally would, when all the cycles have finished remove basket and jewelry.  If there is any remaining residue, use a soft bristled toothbrush to brush it away while running the piece under hot water.

NOTE:  The first time or two that you use the basket the locks on the outer basket will be a little difficult to secure, but after that it will be very easy to operate.  Initially, you can follow all of the above directions and when you are ready to secure the top half of the outer basket to the bottom half.  Make sure that all the edges are lined up on the outer basket and then set the basket on the counter.  Using the heel of your hand, tap the top of the basket directly above the locks with the same force that you would use on a stapler.  Make sure you secure both locks in this manner.

Once the dishwasher has finished the cycles, remove jewelry.  Brush away any remaining dirt or residue with a soft bristle toothbrush,  If the jewelry has not been cleaned in a while and a lot of dirt remains in crevices, run item under hot water while brushing or poking the dirt away.   

Do not place more than one ring in the Jeweler in the Dishwasher egg at a time as this may cause metal to become scratched or stones to chip from hitting against each other.  Placing more than one pair of stud earrings in unit at a time is completely safe.

Do not place chains, opals, pearls, turquoise, onyx or any rings that have stones that are glued in.

Jeweler in the Dishwasher is not responsible for any stones that may become dislodged or lost during the cleaning process.  Jeweler in the Dishwasher accepts no liability for any damage to mountings that may occur during the cleaning process.

Instructions for using Jeweler in the Dishwasher

Jeweler in the Dishwasher LLC

Simple Design.  Professional Results.

Phone: (913) 687-8010      Fax: (913) 871-7746

    Soaker tank.

Click on image for a larger picture.

For additional SILVER CLEANING directions click HERE

                 Unit.

Directions